What is the purpose of multiple autopilots?

fooot
  • What is the purpose of multiple autopilots? fooot

    I have read that some airplanes have multiple autopilots, specifically airliners.

    What is the reason for this, and how does that system work?

  • Redundancy, particularly during autoland operations.

    How it works depends on the specific airplane type. In the most advanced systems with triple (or more) flight guidance computers (FGCs), a "voting" concept is used during critical operations like autoland. All 3 computers calculate their commands independently, and vote on what to do. The middle value, or sometimes the average of the 2 "most similar" values, is then passed to the flight control actuators. In this way, if any one of the computers fails and starts producing garbage commands, those erroneous commands will not be selected (they are automatically rejected by the voting scheme). A monitoring system can also detect a failed computer in this way and take it offline, allowing "fail-active" functionality — an autoland can continue on the 2 remaining functional computers.

    Less complex aircraft, and aircraft without autoland, still sometimes have 2 FGCs, but do not support fail-active operation. In these systems only one of the two computers is active or selected at any given time. A transfer switch in the cockpit allows the pilot to transfer control from one computer to the other if one fails.

    And it's not just airliners. Business jets commonly also have dual FGCs, and in recent times even small general aviation airplanes like the Diamond DA-42 have dual systems (Garmin G1000 in dual-GFC700 configurations).

    CJ Plus

    This photo (click for high res version) shows a Cessna Citation CJ business jet with dual Garmin autopilots. At the top of the PFD, notice there is a small green arrow pointing left; this indicates the left FGC is currently selected. The photo also shows the XFR (transfer) button on the mode select panel, top center, just underneath the master caution/warning annunciator panel. Pushing this button would switch to the right (#2) FGC and change the arrow on the PFD to point to the right. These indications are fairly representative of other dual-FGC systems.

    Here's another photo of a Hawker 800 with Rockwell Collins Pro Line 21. You can see the same arrow on the PFDs. In this aircraft the transfer switch is labeled "AP XFR" and is again on the autopilot panel just underneath the glareshield at the top of the panel toward the left hand side.

    And finally a photo of a 767 with 3 FGCs and full autoland capability. It's a bit hard to read in this photo, but just above the autopilot disengage bar (the "spacebar" looking thing on the right side of the mode select panel just under the glareshield) the 3 buttons are labeled "A/P ENGAGE", "L" "C" and "R" for the left, center and right FGCs. During an autoland all 3 would be selected and illuminated.

Tags
Related questions and answers
  • I have been using an Android app to track flights. Their information is pulled from their own proprietary database, and some (with 5 minute delay) from the FAA. I was thinking about making an app that would do this as well by pulling from multiple data sources. What are some good APIs, either paid or free, that gives you near realtime data of flying aircraft?

  • To most non-U.S. pilots who have little or no experience flying in the U.S., the concept of a FBO is not very well understood. What exactly is a FBO and what are the services that it can provide? I've heard that they can refuel your plane, move it to a hangar, clean it, provide preflight planning facilities, etc. Is there a charge for these services (I guess so) and if so, what can be expected? I've also seen many airports with multiple FBOs. How does that work? All I know is that FBO stands for "Fixed Base Operator". This may seem like a very stupid question but in Europe

  • This is a followup to What data does ACARS send back to base? Can it be used to track a plane? I had asked this as a part of the earlier question, but it seems to be a large enough issue to be separate (plus no answers covered this aspect). All electronic communication systems have low level diagnostic and channel check packages (commands). By pinging, I mean to send a system specific query message, and estimate the response time at base station or first receiver. Repeat the procedure multiple times, and calculate the response time differences. (Assumption) If the response time

  • I just finished reading an interesting post where the author suggests that the missing Malaysian Airlines flight 370 could have 'hidden' under the cover of Singapore Airlines flight 68 to fly to a covert airstrip. I've read multiple thrillers where submarines have hidden behind the acoustic signal of large cargo vessels to mask their sound over sonar arrays, and this (at least in the book) sounds plausible. I also read another book where a bomber (flying under the identity of a commercial jet) masked a business jet to get it into an area without detection. Naturally, both examples are taken

  • I have read that some airplanes have multiple autopilots, specifically airliners. What is the reason for this, and how does that system work?

  • Let's say I call up Wx and have the wind direction and I know the runway headings from my charts and the pattern is empty. I can do the math, but it's tedious and slow and even worse when there are multiple runways. This is what I usually do: Runways are 13 and 31 Wind is 253° which rounds to 25 $25-13=12$ $31-25=6$ I'm going to use Runway 31 Is there a trick to determine best runway quickly without doing the math?

  • In a recent flight on an Airbus A380 I noticed that its ailerons are split into three segments which move independently. What advantages does this design have? Do other aircraft have split ailerons (or other control surfaces)?

  • I've seen on numerous different constant-speed propeller aircraft and different pilots using different RPMs during the cruise phase on a propeller aircraft. What dictates the RPM used during normal cruise operations, and why is that the case? Often there are multiple possible throttle/RPM combinations that deliver the same power, so where would you pick one or the other?

  • Is there a procedure in place to request a copy of the audio recording of a specific ATC position over a specific time interval? How is the request made? What are the limitations of such a request? For the purpose of this answer, consider that there would be a need for the audio from a controller, which may involve multiple frequencies as well as interphone communication with other controllers. As such, internet resources that provide recordings of specific frequencies would not be adequate.

  • I've seen multiple videos online of evacuation slide tests and they all tend to be almost violent as they are very fast and loud, but I can't help thinking that it must put a lot of force on those seams when they inflate and along with that the material. Is there any limit to how many times these may be deployed before they must be retired?

Data information